I've noticed that my Emag has a tendency to chop paint when I empty out the warp feed hose by firing with the gun tilted at odd angles. And not just broken paint, that with a few shots is clean. We've got the full porn-movie-money-shot-out-the-powerfeed cleaved in half ball in the breach.
My barrel has good nubbins, and the whole assembly is free of burrs and scratches. The paint isn't too big.
I'd like to suggest an addition to the bios on the EMag that will allow the Spin-the-warp-feed signal the is sent to the connecting wire to continuously spin as long as the trigger is down in order to refill an empty warp feed path. It would help me immensely to be able to refill the pathway without firing the gun, trying to poke the little white button, or hitting mg gun to tile the shock sensor.
Is that something that can be done with a software upgrade to existing units?
Itchy
My barrel has good nubbins, and the whole assembly is free of burrs and scratches. The paint isn't too big.
I'd like to suggest an addition to the bios on the EMag that will allow the Spin-the-warp-feed signal the is sent to the connecting wire to continuously spin as long as the trigger is down in order to refill an empty warp feed path. It would help me immensely to be able to refill the pathway without firing the gun, trying to poke the little white button, or hitting mg gun to tile the shock sensor.
Is that something that can be done with a software upgrade to existing units?
Itchy