Intelifeeding Warpfeeds...how do I do that?

[Jackel411]

I see it has a little plug in port next to the " preload button "

Im assuming it has something to do with that. Any ideas?? Schematics???

Also.. is there a way to have one warp feed trip another warp feed?

[Beemer]

here

Go here http://www.airgun.com/manual.shtml Bottom of page

[ThePixelGuru]

Go to the address in the post above this one and figure out how to make the wire you need. Then split the wire so that the same microswitch is connected to two plugs. It'd be way easier than trying to make one warp trip another. Good luck with your backpack loader. (Just guessin'...)

[Jackel411]

Oooooh.. good guess..

Actually it should work.

I have the bottom warp taking paint from the " hopper " and pushing that up 1 foot to the top warp.. The top warp is keeping the force on the ball stack for the gun.. So although it may not be constant feed it still will be able to shoot with very little lag time on reloads.

So far... 10.00 bucks spent on some industrial equivalent warp feed hose.. YAY!