Help my Rt is leaking out of the back!!!

[BluVision]

I traded and got the rt and when i first got it i had like 900 psi in my n2 tank and it fired and there was no leak. I went and got my tank filled ( pmi 88/4500 pre-set) and it was leaking out of the back around the valve and i have tried every thing from oiling it to turning it to like 240fps and it was still leaking untill i got abot 1000-1200 psi left in my tank and then it stops( i got the tank filled up again yesterday and it did the same thing again). What can i do to make it to where it stops leaking all the time?

[a_malfunction]

Make sure it is well oiled. If your velocity too high, it will do that. Make sure it is low enough and well oiled. It that doesnt help, call AGD. They'll be glad to fix you up.

[DaXtremeist]

well first thing ya really should do is change the Regulator Seat

[Thordic]

It sounds like the tank. What kind of input pressure are you running? I think if you have too much pressure going into the valve, it will blow out the back no matter what FPS you run.

If its adjustable, turn it down, or empty the tank, open the reg, and clean everything.

[BluVision]

The tank is brand new and it is a pmi pure energy preset so i assume that it is 850psi

[PyRo]

Originally posted by DaXtremeist
well first thing ya really should do is change the Regulator Seat

The reg seat on the rt is an o-ring, not the same as a regular mag...

[TheBigRaguPB4L]

correct me if i'm wrong but couldn't it also be the reg piston?

[PyRo]

Possible, but they usually last a while.

[tomcat]

If it's leaking from the velocity adjustment knob/allen wrench hole, try holding down the trigger when you screw in your tank.

[PyRo]

It leaks out the front not the back when it doesn't get enough air. Try turnign down the velocity...