What will Intellifeed increase my 12v Rev.'s b.p.s. feeding rate to?

[The Mag Man]

?

[PyRo]

Should help it out some, especially if you have the rev with the delay.

[The Mag Man]

Up

[davej946]

It will increase it by EXACTLY 2.4 bps...

There is no actual way of knowing. There are no test results (to my knowledge) on this sort of thing. It will help, but the 12V already does 10-12bps and it is unlikely that you can actually pull the trigger that fast, much less any faster.

[PyRo]

The rev turns on when it detects a gap between the balls. This means that when it turns on the gap already exists, with the intellifeed it turns on ever time you shoot, so this gap shouldn't exists.

[[NA]WARLORD]

Will it work with the x-board ?

[markhauguel]

The mod effectively puts power directly to the servo motor in the loader so it will work without any board in the loader. I hope this helps, good luck

[Dealaman]

Yes

It works on a revy with or without x board. Go to www.airgun.com/manual.html and there is a step by step instruction thing that shows you how to put the intelliframe on a lot of things.