so cold my warp plate fell off

[dorksquad]

i was playing yesterday with my proteam warp feed, and the pressed on vibration sensor plate kept falling off,well one time it was gone for good. i can probly call and get another one, but i was wondering if the agd warp bodies and ptp warop bodies are the same, and if so then can the sensor be mounted inside like the agd version. i might also try some alternative mounting options, or maybe intelllink the whole thing up. just looking for some thoughts

[magc68]

the ptp version has an external sensor and the agd has an interanl sensor. the agd mounting plate has no area for a sensor and the ptp does. u can have a internal sensor installed on your warp by calling agd and telling them your problem. it may cost u a minimal amount.

[dorksquad]

i could just do it my self i wanted to know if the bodies were different

[PyRo]

PTP doesn't make warpbodies, only AGD does.
The AGD warpfeeds have a sensor mounted inside of them, and the PTP warpfeeds have a sensor in the rail.

[BlackVCG]

No, No, no... he's asking if the warp shells are the same so he can mount a vib sensor in his PTP Warp. To answer the question, I believe they are. Call AGD and see if you can get a cut sensor and two springs. That's all you need to set it up for internal vib sensor.

If you could get a pic of the board and a pic with the board lifted up so I can see if there's the proper holes under it, then I can tell you for SURE if you can use an internal vib sensor.

[dorksquad]

thank you, someone understood me. i will get a picture up soon, have to hook the camera up.