Emag leak out of side of valve...

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • cledford
    Registered User
    • Feb 2001
    • 1386
    #1

    Emag leak out of side of valve...

    I'm experiencing a slight leak out of one of the pinholes in the side of the Emag valve body. I played with the Emag, and it worked OK, but I may have been having some velocity fluctuations due to the leak.

    Basically the leak is in the forward (towards barrel) of the 2 small holes in the side of the valve body.

    I had the Emag into AGD for service about a month ago, and one of the actions they took was to replace the on/off pin with a different length (not sure if they went up or down), anyone know if this might be the problem? The valve is oiled, so that isn't the problem.

    Thanks,

    -Calvin
    From a poster at PB Nation:

    ""Jim, back to your cave. Bob Long is on the batphone..."

    MY FEEDBACK
    Tags: None
    • TITAN
      kAmAkAzEe of PBN
      • Sep 2001
      • 350
      #2
      check the orings
      D . Y . N . A . S . T ... Y!

      iR3

        Comment

        • AGD
          The man from AGD

          • Oct 2000
          • 5916
          #3
          Hi Calvin,

          If it's the two holes in the back regulator body then likely your regulator piston oring needs to be cleaned or replaced. If it's coming from the vent hole in the front valve body then its a problem with the valve pin orings.

          AGD
          sigpic

            Comment

            Previous template Next
            Working...