PDA

View Full Version : is this a UMF and what's the going rate?



TackleDummy
01-19-2015, 09:24 PM
I bought this for a project that never happened. I thought it was a UMF. Can anyone confirm?
Also, I believe the last one I saw sold here went for $200, used. Is that normal for these?

side
90741
bottom
90742
top
90743

captian pinky
01-19-2015, 09:50 PM
yes it is a logic umf. this one is raw i would expect to get less than $200 for it because of 2 reasons. it has to be used with a rail longer than am/mm and it is raw.

TackleDummy
01-19-2015, 10:08 PM
Thank you. It's been quite a while since I messed around with the automags.

Nobody
01-19-2015, 10:24 PM
The rail length means nothing to the price.

Some people would prefer raw, since it hasn't been over anno'd and whoever would want it can have it fresh.

I'd start the price at $250 and work the price down, depending on how bad you want to sell it.

knownothingmags
01-19-2015, 10:43 PM
The rail length means nothing to the price.

Some people would prefer raw, since it hasn't been over anno'd and whoever would want it can have it fresh.

I'd start the price at $250 and work the price down, depending on how bad you want to sell it.
wow these are really spendy frame huh?
just for mechanical

robertreed711
01-20-2015, 10:24 PM
I could be wrong but I think those estimates are awfully high considering it's raw. I bought a raw one for $125 or $135 shipped less than a year ago and then paid $85 to have it anodized. So, in my opinion $200ish would be about right if it was ano'd, but not raw.

alpha_q_up23
01-20-2015, 11:18 PM
I seen one sell on MCB a week or so ago for around 180ish and was annodized black by Caustic

TackleDummy
01-21-2015, 09:27 PM
FYI, I sold it for $185.