PDA

View Full Version : How do you remove your Mag trigger?


The Mag Man
04-30-2002, 02:30 PM
I have an Intelliframe and i'm wondering how I would go about removing my trigger for powdercoating purposes.
BlackVCG
04-30-2002, 02:56 PM
Take a drift pin and knock out the trigger pin from the safety side of the frame. One side of the pin is knurled.
FrAuStY
04-30-2002, 03:12 PM
As BlackVCG stated if you were holding the triggerframe like you'd shoot it.. tap pin from the right side to the left side. if you tap it more than 3/16" and don't see either knurling or like mine was smashed on two sides to make it look like this =O= . Then you may want to tap other direction. :) Hope this helps.
The Mag Man
04-30-2002, 06:07 PM
How would I put it back in then? And what would I "tap" the drift pin with? A hammer?
echoes
04-30-2002, 07:19 PM
A related question... can AGD sell just the trigger for the intelliframe?
The Mag Man
05-01-2002, 03:08 PM
Up!
spazzed
05-01-2002, 05:00 PM
I'm in the same boat, I'm having problems getting the trigger pin back in. Anyone got any hints?
FreshmanBob
05-01-2002, 05:06 PM
loctite!
spazzed
05-01-2002, 05:13 PM
uhhh... no.
FreshmanBob
05-02-2002, 06:49 AM
no really, if your having trouble getting the pin back in tightly, put a little bit of loctite on the side that goes in last. It might work, im not sure but use a lower strength one just incase