View Full Version : Question about Macro line
Timrevo13
05-14-2002, 07:12 AM
Unfortunetly i currently have my minimag running on co2 , i threw an Xchamber on there to try and help the scene a little. Everything is Macro line but it seems to want to leak from all the elbows where the macro line goes in. Anybody have and suggestions?
take the line out and check to see if it is a straight edge at the end of the fitting. Also see if there are a lot of wear / marks around where the line fits in the fitting. hope this helps
Timrevo13
05-14-2002, 07:37 AM
thanks ill do that
Bartleby
05-14-2002, 12:26 PM
a good idea would be to apply a tiny bit of gun oil to the end of the macro line where it enters the fitting. this will ensure a tighter fit. if that doesn't work you may want to consider making a new cut on the line so that the fitting can properly recreate a groove on the end of the line.
the last one always works for me.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.