first shot good than all the rest is bad

[mtabion]

When i first shoot the first shot the velocity doesnt seem to be building fast enough for the rest and usually i have to wait before the air builds up. I have a RT. and also when i do multiple shots i hear air coming out from the regulator nut...is that natural?
I tried adjusting the trigger rod length 1/16 rod to trigg but than there's no 1/16 gap after i pull the trigger. I called AGD techs and they said to adjust the rod length 1.990 i did and it wont shoot i even bought a new sear and still the same prob.

[Tyril]

Hmm... I had a similar problem with my minimag a whiles back. After many diagnostics, I finally saw the obvious: the trigger would "ride" the sear after a string, never really closing the on/off, and causing massive shootdown. I don't know if your problem is the same as mine, but try to see what you can do to get the trigger directly off the sear rod. I cut a tiny notch in the back of my stock trigger, fixed the problem right up.

-Mike

[mtabion]

I was thinking of doing that and keep the 1.990 trigger rod length but was'nt too sure of that but since you tried it i just might do it with the stock trigger so that i don't ruin my chrome one...
One thing i found out was when i installed the intelliframe the hole in the field strip screw did not line up with the inlet air that comes from the supply so now i have to find a thin washer so that when i tighten up the field strip screw the hole will lne up...By the way i just crosstread my screw in hole on the rail where i put the 90* fitting. Now i have to go find a threader and rethread.

[a_malfunction]

You should probably send it in. They'll get you up and running!

[mtabion]

I'll probably do that and make them do a real good tune up