Minimag with hose on LEFT side of valve...

[Sputnik]

Whats the story on this? I've seen a minimag which is hopper left but the valve also has the inlet on the left side. Most mags have their valve inlet on the right if I'm not mistaken.

Whats the scoop and is this a good/bad thing or just something AGD tried out?

Thanks.

[Schnitzel]

there are 2 types of minimag setups:

hopper left
hopper right

the air inlet depends on which direction the powerfeed goes.

if it's hopper left (powerfeed soldered onto the right side of the body), then it will have an inlet on the left side because it has room to pass underneath the powerfeed. It's also reversed for hopper right minimags.