were do i put the interlink cable on my revvie ?

[speedballbanks]

so were do i put/connect it i mean i have looked in there and there isnt any ports like the phone jacks that you connect the other end too

------------------
joey banks

chrome powerfeed left
retro valve
gadget
teardrop
max attack
9 converted 18 v. hopper
benchmark rail and double
getting a warp

[magc68]

the emag interlink will not work with the rev unless u do Rob_AGD warped revy mod.

http://www.automags.org/~RobAGD/warped-stuff/warped-revy/

------------------
Team Recursion's Website

[PyRo]

Hmm, Mag68 i'm pretty sure that their is another way to do it. Just not sure what it is.

[speedballbanks]

ok you know how the angels have the intellifeed were do they hook it up inside the revvie

------------------
joey banks

chrome powerfeed left
retro valve
gadget
teardrop
max attack
9 converted 18 v. hopper
benchmark rail and double
getting a warp

[magc68]

the emag emmits a electronic pulse through the interlink cable. this pulse is used by the warp feed to trigger the motor. similar to the eye in the rev. i dont know too much about this stuff but i think u may be right.

if there is a way to use the pulse instead of the eye then using the revs batterys u should be able to make the rev spin.


i have no idea about this. this is just a theory. someone with more electronic knowlage would have to help me on this.

[magc68]

the angel interlink is totally diffrent than the emag interlink. u can not compare these 2 as they do 2 totally diffrent things.

[2UnREal]

This is what you do if you hook up the revy directly to a switch. Now, the intellifeed won't work unless the switch you use is a special switch. It's the type of switches that are found in telephones. The look like a dome, the dome being rubber, and there is a piece under it that once pressed it will send a signal. This is what you have to do:
1. Take the rev apart.
2. Unhook the Eye and take it out.
3. Get 22 or 21 Solid Gauge wire.
4. Stick the wire into the green and white slots.
5. Hook the wire to the switch.
6. Turn on rev and press the button.

If you used the right switch it will work. If you want I will post a pic of the switch. Hope this helped!

[magc68]

i have a post on here somewhere that describes that method of a rev intelli feed. they want to know how to do it with the emags interlink cable...

[speedballbanks]

ok can you post a pic

------------------
joey banks

chrome powerfeed left
retro valve
gadget
teardrop
max attack
9 converted 18 v. hopper
benchmark rail and double
getting a warp

[2UnREal]

Oh, if it with an Emag I dunno how to do it. You may be able to get away with hooking the cable to the green and white wires like I said.

[donggie]

I was thinking it would be easy to hook up the interlink to the revvy sensor to make it spin... but I remembered that there would be nothing to dictate how long it would spin or if a ball was already in there or not. Just a thought. Warp revvy mod may be a better option.

Don