• robr81

    There is no available content written by robr81
  • Recent Posts

    Nobody

    Mag and pump project parts

    You would need a the lug thag threads into the pump are. I do not know if snipers have that, but overall it will work with an Empire sniper. A WGP sniper

    Nobody Today, 04:33 AM Go to last post
    eelz

    Emag Trigger, with or without bearing

    The triggers fitment regarding 'play' is only as good as the frames machined slotting tolerances,though. I doubt very much that any general marker assembly

    eelz Today, 04:32 AM Go to last post
    Nobody

    Emag Trigger, with or without bearing

    If a trigger is machined properly to tolerance, then shims are not needed. AGD didn't need them with thd Emag, Intelliframe or even the Tunablades. Just

    Nobody Today, 04:20 AM Go to last post