Help, air coming out the back
I've had an automag rt pro for a couple of years now but never took it apart. I am trying to install the level 10. I followed the directions from this site and now air automatically and periodically comes out the back hole where you can adjust the velocity. Can someone please help me?
Mike
Bolt stick and gas leak Level 10
I installed a level 10 kit on my hyperframed micromag and its worked good for a while(I dont play that much though) and a month ago I was playing and had to use CO2 until I got my nitro tank Hydro tested. And while I was playing the bolt started sticking and gas would escape down the barrel really quick and I would have to push the bolt back to get the gas to stop leaking I fiddled a bunch with the velocity and changed my on/off orings hoping I could get it work and it would'nt. Thinkin it was the CO2 I finally got my nitro tank back and tried it but my gun would still do the same thing, Ok so now Im thinkin that my level 10 kit has reached its breakin point so I used the troubleshooting guide on my level 10 CD. My original Conf was a 2.5 carrier with 2 shims. I tried a 2 carrier with same oring, then with new oring, then took out shims and then added shims, while adjusting through the range of velocity each time I tried something different. It did'nt leak as bad and the bolt would now recock when I changed this stuff but it still would'nt shoot just little gas puffs when I pulled the trigger. Im tired of spending money on 60 mile drives to my paintball field and nitro fills. I dont know if this is a problem with my level 10 kit or maybey the CO2 messed up my gun up but I had used CO2 on my gun before and its never messed up like this and my on/off pin looks fine. Please help me if you can.