XMOD Change Log (OFFICIAL)

These are the comments I made copied and pasted exactly as they are in my source code.


;* Revisions
;*06.18.2006 XMOD BETA 1.8
;* If the EEPROM is reset due to corruption the display brightness will be reset in all cases
;* Ramp Start is an option with hardware programming.
;* Top Button now cancels Boot message early
;* 04.15.2006 XMOD BETA 1.7
;* Fixed PR-T mode to never display more than ROF
;* Fixed all Numbers so they do not display a leading zero
;* 03.29.2006 XMOD BETA 1.6.1
;* Fixed EEPROM resetting when any value was cycled
;* Fixed goofy characters that were being displayed when PR-T mode was first enabled.
;* 03.23.2006 XMOD BETA 1.6
;* Fixed Solid pull of solenoid when Low Battery allert did come on
;* Fixed Low Battery Message (It wasn't working)
;* Added Self healing EEPROM (after corruption)
;* Renamed all code with DB or DBounce to FIX
;* Created DISPLAY_ONLY and VALUE_OFFSET_1
;* Changed numbers to be single digits
;* Increased max FIX to 95
;* Added MIL MODE
;* 12.31.2005 XMOD BETA 1.5
;* Increased DLAY max from 3 to 8
;* Smoothed out PSP ramping
;* Eliminated Display.inc line 140
;* 12.24.2005 XMOD BETA 1.4
;* Changed bottom button counter to use XH,XL instead of YH,YL so ACE can be toggled in PR-T mode
;* Added Option to turn Solenoid off in PR-T mode
;* Changed Functionality of PR-T mode to save value after last trigger pull
;* Fixed all catastrophic bugs in PR-T mode(Display still goes goofy sometimes but it doesn't affect anything else)
;* Uncommented Power Saver
;* 12.18.2005 XMOD BETA 1.3
;* Added PR-T mode
;* 12.17.2005 XMOD BETA 1.2
;* Changed Automatic warp advance in Modes.inc to use an rcall(Saves Code, while adding 3 cycles to a trigger pull)
;* Added Fried Board Test
;* Changed Optns to r17 (Adjusted EEPROM to reflect)
;* Commented Power Saver
;* Commented Sleep Mode
;* 12.15.2005 XMOD BETA 1.1
;* Added Sleep Mode
;* Added Power Saver
;* Increased nop's from 2 to 4 in manual warp advance
;* 12.12.2005 XMOD BETA 1.0
;* See PDF for full list of features