Originally Posted by
Mic0157
Okay forum correct me if I'm wrong. I have an AM with ULE / X-Valve / Lvl 10 / intelliframe and just dropped a ULT trigger in and now the sear won't consistently reset. I've read up on this and it appears I need to remove a shim or two? Does that sound right? Start tuning the ULT by removing all of the shims. Add back in one at a time to adjust it to your liking.
Next question, I want to shorten the creep on the trigger pull. From what I've read you can't just go twisting the trigger rod since he on / off valve may or may not catch. Again, is that correct? Sear rod should sit about a credit cards thickness from the back of the trigger when aired up. IIRC, there is an exact measurement in the Tolerances thread. You may have to adjust this after adding/removing shims from the ULT.
Last one, on the tip of the Lvl 10 is that little black rubber cushion. Well mine just fell off. I had an extra and slipped it in but it fell right out. Will superglue hold that in? Too small for duct tape. ;)Yes, it has to be glued on. Super Glue will work, but make sure you clean any residue off the bolt before attempting to glue it on. Any oil or bits of the previous foamy can cause the bond to be weak.
This is my first AM so I'm being cautious with adjusting it.