should I melt the revy to go around the warp feed hose or should I cut a hole in the revy and run the hose thru it.:confused:
Printable View
should I melt the revy to go around the warp feed hose or should I cut a hole in the revy and run the hose thru it.:confused:
Cut or melt a hole.
I melted one and didn't like it. The other side is now a spare part.
It's cleaner with a hole. Heat up a knife to cut the hole its easier then a dremmel
http://home.comcast.net/~beemerone/WarpFeedXMag.JPG
I bet a forstner drill bit would do magic for that.
I would use a hole saw...
http://www.eastwood.com/media/catalo...95/p43042a.jpg
Keep the blimp on top. Why add more weight to an already heavy gun...
Not that it will matter or change anything.......Quote:
Originally Posted by Nobody
X2
nostalgia, besides going remote air is taking a 3 lb tank off the marker so i net a 2 lb loss.
never thought about it but blimp is a good name for them.Quote:
Originally Posted by Nobody
Got that from Beemer. He infected me with the name...
If you offset the angle of the Warp enough you don't have to do neither...just my 2€ents
Quiet Sally, your noodle arms are a testament to you lack of knowledge and absence from the way of the warp.Quote:
Originally Posted by Nobody
A hole saw and dremel are your friend in this case. I recommend only drilling one side of the shell. Allows for super tight setup. I guess doing half and half might allow bringing it even closer , but then thumb clearance becomes an issue.
I second the hole saw idea. Much cleaner and you can rent them at local hardware stores if you don't already have one.