Printable View
I was using my Karta for about 3 games, when suddenly the Level 10 Superbolt gets lodged hard inside the Karta body. After I got home, and had to pound it out with a screw driver and a hammer, it was jammed in so hard. I've since tried the Karta on a few other set-ups with a few other bolts, and the same thing happens with all of them, so it's not the bolt. What would cause my Karta body to suddenly get a smaller orifice?
Sounds like the steel ring and c clip are missing from inside. They prevent the bolt and spring from tearing up the soft aluminum.
check detents
Take the body off the rail. Take the detents out and drop the bolt into the back of the body to see if it fetches up.
Do you try what I suggested? I like to assemble minus the grip frame and bolt spring (no air, duh) to see how well the bolt cycles by hand (pick actually) ;)
Is this the valve assembly I drilled the broken parts out of? If so it wouldn't hurt to get a good cleaning, all I did was blast it with compressed air, it could easily have bits and pieces in it.
I wonder if a piece of broken tap could have somehow jammed it up? Did you retest it after un-jamming the bolt?
Quote:
Originally Posted by luke
Nope. I have not rebuilt that particular X-valve yet. Yes, I've tried a few different simulations, as you suggested, with 2 other valves, and they are all catching. I even pushed a Level 7 into it, and it's catching as well. Can I file the inside of the Karta with a rat tail file, or will that lead to disaster?
have you tried this, cycle with air or not, but try without any detents. I had one where the detents were going to deep into the body, catching the bolt every 5-10 shots.Quote:
Originally Posted by athomas
here is a nice thread about tha C-clip and S/S washer since your not sure if you have one installed:
http://www.deadlywind.com/tech/ring_clip
Quote:
Originally Posted by need4reebs
This is the problem! How do I get these missing pieces? Thanks need4reebs. I'm amazed that you found these pictures.
What do I do if I "mushroom headed" the inside of the Karta? Can I file down the slight flange that I created by not having the steel washer inserted?
Quote:
Originally Posted by djinnform
yikes!!!!!!
Yes, you can. You should get the parts you need before you use it again, though.Quote:
Originally Posted by djinnform
Does AGD sell the steel washer? I found the c - clip , but not the washer.Quote:
Originally Posted by athomas
give them a call in tha morning or try PM'ing Tuna to see if he has any available? thats gonna be your best bet?Quote:
Originally Posted by djinnform
Quote:
Originally Posted by need4reebs
http://i1108.photobucket.com/albums/...8.jpg~original
I do believe they do! I just got some a couple months ago.Quote:
Originally Posted by djinnform
http://store.airgundesignsusa.com/in...fo&prodId=2070
Thank you. I looked for 30 minutes on the site, but could not find that piece.Quote:
Originally Posted by barkingspider