mag wizards needed

Printable View

04-13-2015, 01:32 PM
Spook

mag wizards needed

Please can you help me with my rt pro valve it is leaking air like there is no tomorrow i have oiled it up and tried to cycle it but nothing happens i have adjusted the trigger still nothing i can put my finger in front of the bolt and it doesn't move if i push the bolt in ever so slightly the leak stops and the same if i pull the trigger in i have i have had a look in the valve and i have noticed that the spacer between the two o rings on the valve pin is split could this be causing the problem any help will be very appreciated
Thanks
Luke
04-13-2015, 03:03 PM
OPBN

Sounds like you need to go down a carrier or two on your L10. Also, have you gone through the valve to insure everything is where it is supposed to be? Has it worked before and stopped working? Where is the leak coming from? Need more info.
04-13-2015, 03:07 PM
Spook

It is leaking from the power tube as far as i can tell and everything seems to be present and correct also it has a level 7 bolt
I could not tell you if it was working before as i purchased it on here as working was told it was aired up and was fine i managed to get some air and found out it was leaking
04-13-2015, 03:13 PM
OPBN

Bolt spring may be worn. Might have to drop a spacer size.
04-13-2015, 03:19 PM
Spook

It's a new bolt spring installed i will get some spacers and spares kit seems to be the best way forward
04-13-2015, 05:29 PM
Cyco-Dude

Quote:

Originally Posted by Spook

Please can you help me with my rt pro valve it is leaking air like there is no tomorrow i have oiled it up and tried to cycle it but nothing happens i have adjusted the trigger still nothing i can put my finger in front of the bolt and it doesn't move if i push the bolt in ever so slightly the leak stops and the same if i pull the trigger in i have i have had a look in the valve and i have noticed that the spacer between the two o rings on the valve pin is split could this be causing the problem any help will be very appreciated
Thanks
Luke

the spacer is supposed to be split, yes. if the leak stops when you hold the trigger, then you just need a new power tube o-ring most likely.
04-14-2015, 12:18 AM
Laku

Could be worn sear as well.
04-14-2015, 01:27 AM
Beemer

Quote:

Originally Posted by Spook

I could not tell you if it was working before as i purchased it on here as working was told it was aired up and was fine i managed to get some air and found out it was leaking

Who did you buy it from??
04-14-2015, 02:44 AM
Spook

Quote:

Originally Posted by Beemer

Who did you buy it from??

I bought it from captain pinky
04-14-2015, 07:06 PM
athomas

As the sear wears, you will need to install a shorter powertube spacer to compensate.