:cheers: LMK which rail you want.
Printable View
:cheers: LMK which rail you want.
ill take a pump milled AM/MM rail
I'll take a RTP rail please.
Would you guys want this FG slot design on your AM rails? It will let you use RTP or AM ASA's, slots allow full range of adjustment within the available space. Speak up either way.
[IMG]http://i550.photobucket.com/albums/i...ps1f33cd2d.jpg[/IMG]
works
^I like it :)
perfect...
looks good to me.
I want it for sure.
OK, I'll change the AM slot as shown and do a two hole slot on the RTP version.
Sweet deal your the man Luke :cheers:
For sure it's way better than adding 2 RTP holes on my AM rail.
Great upgrade !
maverick, I've made a note to refund the dollars for that... ;)
Cool, man.
Thanks a lot for this.
AM Armada, invoice me. Thanks!
I'll take a AM pump milled.
Discount pricing closes thursday 10-24-13 at 12-noon mst.
If you currently have an unpaid invoice it is good until then.
Pump milled AM please.
:bounce: Currently machining pump slots.
Luke, can you take a pic of the RTP sear pin hole? I would like to see how it fits with the milling, thanks.
I am interested in a pump milled warp right rail, I am not sure if I want RTP or AM though, if you could get me a pic of the passenger side of the RTP it would help.
Sorry for being a pain :)
-Evan
I don't have any rails to get a photo of, I sold and shipped the rails that are machined.
You'll never have a perfect scenario with this type of machining on the side, but with that said it does not look bad to me. It sticks out a little, but the pin tip can be ground a little for it to sit deeper in the rail. (Grind the tip that goes in the rail first) But even without that I think it's OK.
I was more concerned about a hole in the middle of one of the peaks as opposed to one of the valleys. I am annoying about things. I have faith in your judgement though, I will take a warp right pump milled RTP rail. Send me an invoice when you get a chance.
Thanks,
Evan
Two cuts go through the sear hole, it's just how it worked out, if you are that picky you may not like it. A sear hole in that valley would expose too many threads in the sear pin, it's pretty deep. ;)
LMK if you still want one...
Money sent!
Got my rails in today and I must say you did a great job on these Luke...options for all bodies w/ the pim hole milled out for classic, emag, and other aftermarket bodies...now with you adding the slot milling up front...must say top notch:hail: if your on the fence about getting one of these you will not be dissapointed...:headbang: thanks again
Hey Luke I want one. Pump milled AM. Just joined the forum, have no idea how to do this.
Ongbak_MAG, invoice sent. :cheers:
Preorder closed 10-24-13