ReTro Valve Leak requestion

There is a small hole on the side of the RT Valve that is leaking. After watching the videos and ordering new rings, I replaced the prescribed Reg. Seat O-ring.

This did not repair the leak.

Is there a second point of failure for this leak?
Is this hole a pressure relief point?
Is it possible to install the Reg. Seat O-ring incorrectly (seems rather difficult to mess up)?

Thoughts would be appreciated.

Is it leaking from the hole in the valve (front) portion or the reg(rear) portion? If front portion, take the reg pin out and clean and relube.

Quote:

---

Originally Posted by OPBN

Is it leaking from the hole in the valve (front) portion or the reg(rear) portion? If front portion, take the reg pin out and clean and relube.

---

There is a small hole to the left (if looking from the rear) where the air is escaping.

http://i50.tinypic.com/audoh2.png

Pull your reg pin assy out and ck the orings. If they're good then you probably have a speck of dirt or a piece of t-tape in the cavity causing the leak. Clean it out and you should be good

Quote:

---

Originally Posted by Ando

Pull your reg pin assy out and ck the orings. If they're good then you probably have a speck of dirt or a piece of t-tape in the cavity causing the leak. Clean it out and you should be good

---

Thanks I will do so this evening and report back