-
Flat line slow pressure
Hi I have a 3000 psi flatline set as 1100psi that is slowly leaking
-turning psi down will shut off small leak
-turning psi at and above 1100psi will increase small leak
-shooting 1-2 shots makes the pressure drop and take 5-6 sec to climb back up to selected psi and start slow leak again.
what would need to be done ?
-cleaning lubing, change internals or else ?
BTW is it possible to order from AGD a 4500 psi internal kit and upgrade ? I left a message to Dave's attention at AGD last week but haven't receive a answer yet probably busy
anyone have a opinion ?
jh
-
No - as your tank is a 3000 tank. You'd need a new bottle to handle the pressure. Secondly, the 3k Flatline and the 4.5k Flatline regs do not use the same parts. Can't just toss parts in.
-
There's really only two working o-rings in them. Is AGD out of the 3k kits? They are standard 90 duro urethane o-rings, but I haven't tried to buy one or two in a while. You only have to degass the bottle to pull the top off; you don't have to take the whole reg off the bottle.
Here's a nice guide...
http://www.mcarterbrown.com/forums/a...6k-beware.html
This too...
http://www.warpig.com/paintball/tech...ne/index.shtml
-
tks
thanks for the answers guys I now have a better idea how to clean and lube this machine maybe it will solve the slow pressure after a shot or two
jh