Printable View
Hey guys,
I picked up a Boo-yah elcd MAG grip, along with some other parts.
As far as I am waware, there should be a specific on/off for this combination, made by Boo-yah.
Can anyone help me with a manual/instructions for the grip?
Would like to see if it fits to my current setup without any issues.
Thanks,
Nickless
There was a specific on/off assembly Booyah made. They are very hard to find. But luckily a AGD ULT on/off will work perfectly. So, I would suggest just using one of those. But make sure your valve can take a ULT. classics and some RT Pro/Retro valves are not able to handle ULT's. All xvalves can though. Enjoy your BooYaah, they rip and are lots of fun. I have two of them and they are fantastic!
Not sure on how to find a manual, but by just going through the buttons you should figure out all the settings pretty easy.
Thanks for your reply.
I should be fine with the settings and good to know that the ULT will work.
I was more wondering about the installation... (which sear, how to install an adjust etc.)
You need the AGD sear to be without the trigger rod. Just remove the rod from the sear, put in a ULT, and your good to go! Enjoy!!!
Thanks a lot for your help - I will give it a try
This a scan of my Spyder manual. Although some is different I would think the programming parts are the same.
http://www.bigevilonline.com/showthread.php?t=6457