Emag valve. On off pin keeps sticking WAY out after degassing.
So, if anyone remembers my travels through "buying a used emag" land, I finally bucked up and bought the pin, rebuild kit, and battery from Tunaman (thanks!). My baby works! In mech, in electro, the whole nine yards.
Now, the idiot I bought it from messed with everything. Even just had to extend the sear rod that goes to the mech trigger to make it so the bolt doesn't stick after two shots. Think I got it right, might be a little too long. But that's not the issue.
After degassing the damn on/off pin sticks like WAY out. It's even further out than if I take the whole assembly out and push the pin down to the top of the assembly, if you can understand my illustration.
What could be causing this most unfortunate event?