Level 10 Installation - ReTro Minimag
Installation Time: About 30 minutes.
#1 carrier (1.5 had a very small leak when pushing the bolt around)
Shot 1000 rds of Anarchy - 0 breaks/ 0 chops
Shot 500 rds of Great American - 0/0
Efficiency: First time using a new tank. Switched from a 47ci nitro duck to a 68ci Flatline. No accurate measurement but I got about 600 out of my 68ci and I used to get 600 out of my 47ci w/o Lvl 10. So I believe it is a bit less efficient. Not to bad
Problems: The first part of the day the marker worked flawlessly. After I removed the valve to show some Mag Haters why they were getting smoked all day I had a few issues. After shooting a few shots, then waiting 15 seconds or so, the next shot would be extremely low pressure the next shot would shoot 2 balls, then everything was fine till it was rested again. I could not detect any leaks and the tank was full and regulated pressure was showing 850 psi. I have yet to be able to go through the marker to see if I could find anything else wrong. Any ideas would be appreciated. (I tried re-oiling it)