LVL 10 Superbolt ll is too wide
I finally received my beta lvl 10 upgrade,after I
assembled the powertube,I put the bolt on and tried to
install the valve.The valve wouldn't seat,I finally
realized that the bolt wasn't going thru the washer inside
the main body,my original bolt goes thru fine,but I couldn't
get the superbolt II to go thru.It seems like there is a bit of a bulge on the tip of the bolt any suggestions would be appreciated.This is on my emag.
Re: LVL 10 Superbolt ll is too wide
I am having the same problem. I just bought my second LVL 10 kit for my RT. I started to set it up and I realized that the superbolt 2 will not go through my RT body. It gets stuck on the spacer inside the body. I tried my superbolt 2 from my emag and it would not work either. My original stock bolt goes through fine. I am assuming that there is either a size difference from body to body or there is a problem with the body. I see that Tom is saying that the body is burred, but I do not see any burrs in the body. I am going to take the bolt and body to work and see what I need to do to make this work.
Originally posted by plaser
I put the superbolt on and tried to install the valve. The valve wouldn't seat. I finally realized that the bolt wasn't going thru the washer inside the main body, my original bolt goes thru fine, but I couldn't get the superbolt II to go thru.