Well, if you are using a rail bushing, and I assume you are, then you have a rail that is out of spec. I wouldn't go with the scotch tape idea. The sear pin is usually tight as it is. You might be able to press fit a solid slug into the rail bushing hole and drill the hole in it so it is forward of where it normally sits. That would push the valve farther forward.Quote:
Originally Posted by factoid
What might work, is if you shave a tiny bit off the inner flat edge of the powertube tip. Its the flat surface that pushes against the carrier. Taking a bit off it will allow the carrier to sit farther forward. Make sure you do it against a flat surface so you don't sand more off one side than the other.
The other option is to shave a bit off the carrier itself. The problem with this option is that it only works on the one carrier. If you have to make a change for any reason, you will have to do it again for the next carrier, and then the carriers won't be interchangeable in other guns.