Re: Still having a problem
Quote:
Originally posted by squidboy69
Ok, I'm still having a bit of problem with my LX.
What does it chrono at?
Re: problem with solution
Quote:
Originally posted by Panzerr
I found that after putting two cases of paint through my new Level 10 kit that i developed a very slight leak in the power tube from time to time. I removed the o-ring carrier and installed the next smallest size and the leak stopped. Apparently the o-ring "broke in" and was a tiny bit too loose.
Is this the appropriate action to take? I noticed today (after about 1 1/2 to 2 cases of paint with Level 10) that I would get a slight leak between shots occasionally. Sometimes shooting the marker would stop the leak, sometimes it wouldn't. I am currently using the 2.0 carrier. From what I read around here, the 1.5 carrier would be my next move?
Also, I am having horrendous efficiency. I shot 600 rounds in a game today and it ate entirely through 68*3000 of HPA.
AGD: If you are leaking only occasionally I would leave it alone because this means you have the least friction on the oring. Reports coming back seem to indicate that using the longest spring gets the worst effciency. Is that what your using?
ben_JD's response to AGD: I am using the middle spring. It leaks only occasionally, but I fear that the leak is what is really impacting my efficiency (roughly 280 fps). Before you posted this response, I added a shim (now up to two) and the leaking seemed to abate. Is this just coincidence, or might that be the answer?
I was using the middle spring, but that still hurt my pinky when I demonstrated the new Level 10 to the folks at the field, so I moved to the longest spring. I will move back to the middle spring, because I am having no problem with chopping. I may even move to the lightest spring, but don't want the bolt to have too much force.
AGD: You should not use your pinky when demoing the marker. Remember, the second half of the forward stroke is under full pressure and will hurt more. Use one of your FAT fingers :)
HEy i have a prob with the level 10 too
OK like i have a emag, warp with 12 X revy.... anyways when i start shootin like i will get a ball caught half way in all the hopper Warp and revy are workin and i only have about 1900 psi in my flatline and its about 90 degrees outside whats goin on with my gun!!!!???!!!!!!!!
BlackVCG: If I deciphered your post correctly, you need to add one or two shims.
Valve won't seat in body...
This may sound dumb - but I was following the level 10 instrutions and got to where it tells you to install the valve assy with old bolt spring into the body. It will not fit into my emag body :) the Valve assy (with new bolt) seats just fine in an automag/warp body, but not the emag. I even took the emag body off the rail. Any suggestions?
-Calvin
AGD: Your main body washer has raised a burr from repeated use. Just go in there with a round file and work it off.