Installed, No Leaks, bolt "clicks", doesn't fire
I just installed the LVL 10 on my Classic 68 after replacing the Piston assembly. I put it back together, gassed it up. I have no leaks, the bolt "clicks" under the pressure, I can feel the air against the trigger. However when I pull the trigger nothing happens.
Any thoughts?
EDIT: Ok I cranked up the velocity ALOT to where the screw is 1 turn from being all the way in. However there is a very slight leak out the back. It can't be the regulator piston assembly can it? That is brand new.
Also I did the squeegee test and it only seemed to work when there was significant pressure to push against the bolt. I don't think a fragile ball will stop the bolt. Am I just paranoid here or should it be fairly easy to stop the bolt after this installation?
SPEED PROBLEM - cannot turn up past 250 fps
I just bought and installed the level 10 on my minimag with an AIR valve. The bolt is installed correctly (at least i think it is), but i cannot get it to fire any faster than 250 bps (i just had it chronoed as fast as i could turn it up). The shop did not know what the problem was but they told me that the bold had been installed correctly. I am using the shortest bolt spring. Any one else have this problem? I called the AGD tech line and they are closed and the message said they weren't open on fridays, and since i want to play this weekend with my new bolt, i figured this was the best place to turn. Anyone have any ideas?
Thanks,
JM