Originally Posted by QUINCYMASSGUY
I got my on/off sent to me all set up ready to go, I think that's how they're coming now. I just popped that badboy in my gun and it was pretty good, threw another shim on and it was better, then I ran out of air cause I was at 900psi to start and spent 200psi because I kept shooting once and getting the bolt sticking forward and venting. Too many Lvl 10 shims had an effect with this, I guess because of less push resetting the sear to start, I don't know. Anyone else had that issue? The pin comes bonded with the pin support and in the ULE bottom too, not sure how AGD connected them (loctite?) haven't tried pulling it out yet. Have any of you who got it after the beta test fiddled with this?
Still can't walk it, and I am definitely starting to consider the idea again of drilling a hole a little higher up on the sear to angle the pin, cutting a little stroke distance off but increasing the reactivity. The pull is so light but without a little shorter pull it's definitely not walkable. Anyone know how AGD gets their sears made? Do they do them inhouse or do they outsource for them? I'd love it if I could pay AGD a little more and have them punch the hole a little higher on a sear before they coat it and set the trigger rod just right for the new angle, keeping it within AGD standards. I'd be happy to pay a little more for it and let them know how it goes if they set it up so I don't have to modify it and risk hurting my baby (All-AGD ULE mag). Beta-test it basically. Can this custom work be done? And before this becomes suitable for another forum....
How many shims is everyone with a ULE body/XValve/Stock AGD rail/Intelliframe setup using? I'm at 3, one above what they send it to you with. Anyone finding the need to use Lvl 10 shims with the on/offs they're sending now?
Frankart, I have not fiddled with input pressure because I use a Crossfire set nitro tank, but the reactivity isn't bad, I haven't shot much but it comes back pretty fast.