Ok i'm running ant RTPX with a 68/4500 Flatline. I just shot the gun yesterday without problem except for losing pressure in the middle of a game and busting out the allen to up the psi on the tank and it was good.
Anyway, after a great day of paintball i came home and started cleaning my equipment. I remembered in the manual it said you could just gas up the gun and swish it in a bucket of water and voila. I did that and voila it was clean.
Later that night i was gonna waste the rest of my paint on some unsuspecting trees when i notice water bubbling out of the valve. (uh oh)
It was shooting a few shots an then sputtering out. So, i figure water must be in the valve. (tough one eh) So I take my sick baby inside and strip it down, clean all the parts, let em get good and dry, check o-rings and parts for wear or tear, re-greased, re-oiled, put it back together again, smiled upon my baby and it was good... to look at anyway.
Now it doesn't work at all.
Ok, so I gas it up. The gun cocks, pressure looks good. Pull the trigger, it fires but continues to spew gas out the front of the bolt. Shut it off, turn it back on. Maybe too high of pressure? I check the incoming PSI; it's just over 600 so it wasn't that. Now i crank down the velocity a quarter turn. Gun doesn't fire but it doesn't blow off. I put my ear to the valve. No hissing anywhere. The trigger is still reactive but it's not firing. I turn off the gas. Gun is still reactive but not firing out air in valve.
Ok, I think you get the idea. Any thoughts? Thanks a bunch.