Results 1 to 2 of 2

Thread: intelliframe to warp to Revvy, any suggestions

  1. #1
    Join Date
    Aug 2003
    Location
    MA
    Posts
    740

    intelliframe to warp to Revvy, any suggestions

    Current setup intelliframe to warp connect

    want to add intelliframe to revy

    I'm not an EE, but I should still be able to figure this out, key word there is should

    i spliced a jack into the intelliframe to warp connection and sent that to the revvy, essentially I have a swithch which when closed sends current to parallel systems


    but for some reason my Revvy is sending current back down to the warp.....must think about it

    any thoughts?

  2. #2
    Join Date
    Sep 2002
    Location
    ohio
    Posts
    269
    The easiest thing you could do is either put another switch in the grip and mechically connect them for the other device or use the NC part of the switch you have already and connect it to the warp then when the warp gets a pulse from the trigger forward it will only spin for the time you set the warp set for, and it cannot feed back to your revy. Make sure you dont have it the other way around because your revy will not stop running until you have the trigger pulled.
    PM me with any questions.

    How to Fly: Throw yourself at the ground and miss. "Hichikers guide to the Galaxy"

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •