When installing the new reg seat how tight do I screw the reg halves together? Hand tight leaves a gap between the reg halves.
When installing the new reg seat how tight do I screw the reg halves together? Hand tight leaves a gap between the reg halves.
You see those 3 holes around the outside? They are for a spanner wrench. That is the tool needed. If you dont have that, a couple of pin or allen wrenches opposite each other will get you a good turn.
https://www.automags.org/forums/showt...light=flatline
take a look around that thread there are links to a ton of info.
Hills
Ok,I got the new reg seat in and while I was at it I replaced all the orings. So why do I still have shoot down?
I got a 2500 psi fill to look for leaks and try it out. I set the output at 900 psi and slow fire and it drops to 800 and bounces back to 900. Rappid fire and it drops low enough that my lx starts kicking in.
Do i need to shoot a few more tanks to break it in?