Asking anyone with knowledge in HPA tanks to provide any assistance they have in this situation.
I have a Center Flag Dynaflow 68/4500 tank. This past weekend, while playing, I heard a pop and air vented out of the front of the tank for about 2 seconds then stopped.
I looked at the tank and noticed my low pressure gauge was way off, Reading over 1500 PSI output. I figured that when the initial high burst of air leaked out it warped the LP gauge reading.
The tank will still operating ok after that little incident, but I wanted to make sure. So I released all the air from the tank and unscrewed the front of the reg off. I took out the Reg spring and noticed 3 black plastic like pieces stuck in the spring.
Other than the black pieces which I cleared out and the bad gauge, the tank still seems to work just fine.
Anyone know what those black plastic type pieces are and is it something that will need me to send in my tank for service? Any help would be appreciated.