I just received my intelliframe today and just got done wiring it up for intellifeed to warp. It turned out great. Works like a charm. Now the "Perfect Solution" for drilling the hole through "Dye" grips so you can plug in you intellifeed wire. DO NOT use a drill. Dry fit your grips after you have completed the wires. Press firmly on the grips to leave an impression of the plug adapter on the inside rubber. Then I used a Grommet hole maker. This is a piece of metal tubing with one end sharpened. Place it against the grip, centering it around the impression, then hit it firmly with a hammer and you should easily cut out a perfect circle. Finished project looked like it was made especialy for it.
By the way you can get these grommet kits at you local hardware store. Make sure you get a 1/4 inch Grommet kit. Good Luck.