automag is leaking help!!

[woodz]

my 68 automag is leaking down the barrel.when i hold the trigger it stops. i replaced all o rings in powertube/on off valve and it still leaked. then i replce the ones in the reg eventhough i knew it wouldnt do anything.. whats wrong with my gun?!!

[Minimag4me]

check the bolt and sear for wear, the bolt may not be catching

[dio91]

hey mand i had the same prob. it was bout 30-40 degress out and i shot the gun almost a dozen times and all this co2 started shootin out the barrel, but when i held the trigger it stopped. i took off the bottomline and 32degrees xchamber and just used it verticly. from what i have hurd dont use mags with horizontal set up maybe that was the prob, anyways try a remote thats what im lookin into


dio

[jimmyjobob]

well if you can get away from co2, do so. your mag will run better and more consistent. you may have frozen your orings.

was it running fine and then the problem or....never ran right.
try changing out your spacer to a larger one, .230,.235
check your on off orings and oil your pin.

make sure you have a rail bushing, the little metal sleeve that your rail screw goes through. that can cause problems.

[wyn1370]

should be posted in tech forum
<---------- that way

[Muzikman]

There would be no problems with the on/off valve. It is either.

Power Tube Oring
Power Tube Spacer (too long, install a shorter spacer)
bad/old bolt spring
Bolt/Sear worn out

If air is leaking out of the barrel and stops then the trigger is pulled, it means that the bolt is not sealing inside the power tube. The reason it stops when the trigger is pulled is that the on/off valve cuts the flow of air off between the regulator and the air chamber.

[Thordic]

Once again no one mentions the RAIL BUSHING!

Check to make sure that your rail bushing is still there.

Its a little metal tube that sits in your rail inside the hole the field strip screw goes through. Trust me, it can cause a LOT of problems.

[jimmyjobob]

read my post again,mentioned it