Results 1 to 7 of 7

Thread: Are the flatline spring pack the same as the mag AIR valve spring back?

  1. #1
    Join Date
    Nov 2001
    Location
    Groveport, Ohio (a.k.a. BFE)
    Posts
    116

    Are the flatline spring pack the same as the mag AIR valve spring back?

    Same as topic?

  2. #2
    Join Date
    Nov 2001
    Location
    Groveport, Ohio (a.k.a. BFE)
    Posts
    116
    anybody

  3. #3
    Join Date
    Oct 2000
    Location
    North Plains, OR
    Posts
    4,956
    No. The Flatline spring pack is tuned for outputs around 800psi, whereas the Automag spring packs are tuned for about 400psi output. The Mag spring packs are all black and the Flatline spring packs have gray washers.

  4. #4
    Join Date
    Oct 2000
    Location
    AutoMag Country
    Posts
    2,029
    If you need to tune the sweet spot on a Flatline for a lower pressure gun like a Bushie/Matrix ect you can put a Automag Spring in it to get better LP responce from it.

    Sweet spot is 320-500psi for the mag spring and 650-800psi for the flatline spring.

    -Robert
    Serving AGD customers since 93, wishing I could beat some common since into some of them about 5 hrs later.


  5. #5
    Join Date
    May 2002
    Location
    Fresno, CA
    Posts
    112
    Originally posted by RobAGD
    If you need to tune the sweet spot on a Flatline for a lower pressure gun like a Bushie/Matrix ect you can put a Automag Spring in it to get better LP responce from it.

    Sweet spot is 320-500psi for the mag spring and 650-800psi for the flatline spring.

    -Robert
    Is the Flatline good enough to run it straight into a Cocker @ 350psi without an inline reg? (Using the Mag spring pack)

  6. #6
    Join Date
    May 2002
    Location
    Fresno, CA
    Posts
    112
    Rob?

    Anyone?

  7. #7
    Join Date
    Oct 2000
    Location
    North Plains, OR
    Posts
    4,956
    It would work fine, but I'd still run a front reg. Leave the Flatline at about 600psi and set the front reg. to 350psi.

Similar Threads

  1. Logic behind sealing back half of valve?
    By Vanced in forum Automags - Tech Forum
    Replies: 4
    Last Post: 09-19-2002, 02:52 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •