Started my mini gun mag

[hill160881]

It will have spinning barrels and will look like the ones in the movies with a 2000 round hopper on top of it.
The mill i used



Here is the piece of aluminum that i am making the EP sear tripping box from. The trigger will sit on top of the marker with the 2000 round hopper in front of the triger frame, so i only need a small hollow block to hold the noid and ram.

A little work with a drill press and a slide vice and we are off and milling

The tools i am using cost less than $200, A ryobi 1/4hp drillpress and a $100 slide vice. It is still ruf but it wont be for long


I cut the ram flat on all four sides and taped it to the noid. The lowers are ready to go

[hill160881]

The hopper material. I wish i had a cornis brake, or box and pan brake. That would make this a fast job but without either i am down to the beat it method. I will be smoothing everything out and make the inside of the hopper less jagged once i have had a successful test run.






The 45k psi back pack air suply.

[hill160881]

The current progress. I added feet, a lid and a cover for the barrels on the front. I also started smoothing things out.



The material for the barrels, 4" cupling, 1/2" pvc tubing, and 1/2" plywood.

[Automag ReTro]

Pulling up a chair for this one

[Smoothice]

I was given a visual demonstration of this beast in person. And even though the mini gun was invisible it was still very impressive!!!!

This ---> is an understatement.

More like this --->

[sjrtk]

I got the recliner in front of the screen.

[Tropical Life]

GO FOR IT!!!!!