Does anyone know how to hook an intellfeed in a hyperframe?
Does anyone know how to hook an intellfeed in a hyperframe?
The last i knew, it wasnt possible, the hyperframe doesnt give enough pulse to activate the warp
AO #765
CCM Series 5
Prerelease Impulse
Hyperframed Warped Mag w/flatline tank
Feedback.
Good to know that somone of Tom's status seeks "relief" from a sport he helped create. A sport now ruled by a single patent.
What do you mean by pulse?
I was thinking about this too,
I dont understand your definition of "pulse". The AGD Intelliframe uses a microswitch to close and open circuit and send a signal to the Rev board. I dont understand why this cant be done with the switch in the Hyperframe.
Im sure it can be done, I just didnt attempt to do it since I shoot a Ricochet.
-Hyper
I figured id give it a shot, and well, it kicks ***!
You intellifed your hyperframe?? How'd you do it?? Give us some more info.
If you go to airguns.com and look at the intellfeed diagram you just do what it says except instead of buying a new switch you just use your trigger switch. the part the blue wires hook to. its really easy the hardest part is getting that frigin switchboard back in its spot.
I tried it and it seems like the trigger on the Hyperframe is in an "always closed" position unitl you fire it. which means your warp will spin all the way up until you pull the trigger
it's a bummer I know.
YOU did something wrong switch the wires or something, mine works great make sure you did it right, try using speaker wire if you have to. thats what i used.
ok nimic, where on airgun.com did you find the diagram. Can you give us a link to it?
the123- you can just change the jumper settings on the warp to fix that problem. grab the instructions that came with it and set your jumpers to "sensor" and "always closed"
http://www.airgun.com/manual.html go there and then go to the intellframe one. with the pic of the intellframe and the revvy.
Hrm. This connects it to the Revvy, but will this connect to a warp?
Legion
I dont know. I dont use a warp. It should.
The way you connect it to the warp is you wire one end to the micro-switch in the Hyperframe and the other end you wire a 3/32" phone plug from Radio Shack. This plugs into the port on the warp.
I hooked my mag up to my revvy using the same instuctions for the intellifeed but instead of mounting the switck inside the frame I used industrial velcro and attached it beside the trigger frame so every time you pull the trigger you hit the switch causing thr revvy to spin, it does not look bad, but it works great.
automag rules