I finally got around to putting m SHP reg on one of my tanks and got a chance to play around with it. Have a couple of questions:
1. Is anybody else reg pin extend a little past the tip of the reg? Every other reg I have, the tip of the pin is flush. Not a huge amount and wouldnt be an issue excepting that I also have a CP on/off where the pin does not recede back past the inner plate. Basically I have to screw the ASA knob all the way in before putting the tank on which makes it somewhat worthless.
2. My Emag w/ Emag valve RT's like a mother. Almost too much as I actually have to make an effort to not shoot a rope of paint. However, I have just the opposite problem with my CF framed, Xvalved Mag. I started with a ULT on/off and it woud not RT. I swapped out for a standard RT on/off and no RT either. I tried adjusting the trigger pin so that it is a business cards distance from the trigger and still no RT effect. Measured the pin, and with the calipers I have it came out to .7545. I know I could try sanding the pin down. I may try another pin from a different valve. Anybody else had a valve that this reg would not make RT?