Sear Pin Question
I have a dallara rail and last week I got a classic sear and pin from AGD. I'm still waiting on a valve to finish putting the mag together, but I was going to put the sear in today. However, the sear pin does not fit tightly. I've only installed a classic sear once a while ago, but I remember the pin having to be pressed in and not being loose enough that it will fall out if turned upside down. Any ideas?
I have encountered both types of pins and have not had issues with either. The one in my Dallara fits loosely as well.
Ok so it's not an issue- I guess the sear holds it in place well enough once it's all together. Thanks!