I just purchased a Benchmark single trigger frame. It came in without a safety, it doesnt even have a hole for one. I also noticed the trigger itself looks a little different on the new one versus another that I have. Does anyone know if the triggers should be interchangeable or not?
*Edit: After trying to swap things around, It looks like the triggers will somewhat interchange, but I am finding that the sear rod sits a lot lower on the frame without a safety than it does on the one with. Also, the way the trigger sits in the frame on the one W/O, it pretty much can just flop all the way forward. Would adjusting the trigger rod out on the one w/o stop this?
** ReEdit: Further noticing that the reason the trigger rod is hitting so far down the trigger is because the bottom of the slot where the trigger rod sits is considerably lower than the other Benchmark frame that I have. I have heard that some older frames were made to fit either a cocker of Mag, would this be one of them?