HALO... skip the WARP

[rukh013]

i'm looking to mount a Halo loader to the side of a TAC 1 body and mod it to feed like a warp (lighter)

http://www.pbnation.com/showthread.p...390&highlight=

what halo loader do i need? rip drive, V35, empire B2, ect...
is there a difference in the shell plastic? i don't want it to shatter
boards/internals? i want to push 15 bps MAX thru ~6" warp tube

i don't know much about Halo's if this is to difficult for this loader is there a better choice under $80 ( not trying to hack up a rotor )

[TimmyJay]

Hope this link is helpful...

http://www.mcarterbrown.com/forums/c...el-a4-fly.html

[xero28]

I'm working on this myself right now. I picked up an MM2K9 so unwanted to run it warp left, but I don't have a warp. I tried setting up my Prophecy using copper pipes, but it wouldn't feed consistently, too much friction and weight of the ball stack to push it I think. I didn't want to hack up the Proph either, so I ran it straight out of the bottom. You will need a Reloader B2 (not B). I just picked one up cheap on PBN. You can also use a Halo Too. I'll be following the same guide that TimmyJay posted for the build, then I'm just going to drill a hole in an aluminum bar to mount the hopper.

[cockerpunk]

B2 was the fastest halo style loader built, which i assume means its the most powerful motor setup. you will want that when pushing paint that high up.

[GoatBoy]

A side feeding Halo is called a "Rip Clip".

[GEE TEE]

This is something I've been planning to do for ages. Got most of the parts I need and hope to start building one very soon.

Got a nice RT mag here that this set up would warp nicely into.