-
Stock feedneck on X-Mag's - removal?
Are the stock vertical feednecks removable on X-mag breech modules?
I removed the two small grub screws in the ends of the breech block, but the neck won't twist out. Are they held in by loctite or press fitted as well? I want to get a new stub pressed in to take either a clamp on or threaded cocker style neck. The stock one is way too small for 90% of my hoppers.
-
very secured press fitted.
they are hard to remove but not possible.
-
if you can get it out cleanly please let me know, i would like to do the same thing and and replace the stock one with a stub tube.
thankyou,
KNM.
-
Using gloves, heat the body with a heat gun or dryer. Then chill the inside of the feed tube with CO2.
Forest Gump of paintball
-
The one I have seen disassembled looked like you cannot twist it out. It had parts that interfered with other parts so that you cannot turn it. I think you have to strait pull to get it out. The heat and cold thing would be my recomendation as well.
-
Ok thanks for the advice so far
watch this space
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules