I have to admit it isnt very exact, but was eye balling it. I put the CF frame on to of it and noticed some areas that it seems different. I may be wrong though.
I ended up swapping around some frames and couldn't get another frame to work with this set up. I then took the valve out and put it in two other setups and it worked fine, eliminating it from the equation. In doing some more fiddling the sear pin fell out and when I started looking closer at it realized that it wasnt a real sear pin, but apparently a ground down nail or screw. Awesome.
Replaced the sear pin with a real sear pin and everything seems to work now.
Guess the fact that there is a nail or something in the trigger pin hole should have been a forwarning.
People!