Trigger question.

[PsychoMag]

I installed a new trigger that I received from a reliable manufacturer of AGD parts. The trigger design mirrors that of the original trigger for hinge, tab, and magnet locations. With my original trigger, when I pull my pin it says AGD 3.2 and is live to cycle the marker. HOWEVER, I installed the new trigger and once it was complete, I pulled the pin and instead of the usual AGD 3.2 and goin live, it had two dash marks and that was it. I reinstalled the original trigger and its business as usual.

Any thoughts?

[Ando]

Hall sensor magnet. Adjust it.

[PsychoMag]

Hall sensor magnet. Adjust it.

Already tried that. It is puzzling.

[knownothingmags]

pull the trigger and far forward as you can,
adjust the magnet as far away from the hall sensor as you can.

let us know whats up.

the magnet might not be able to get far away enough from the sensor.

if this is the case talk to luke. he will help you out on his products.

[PsychoMag]

I thought I that. Magnet is already retracted all of the way and the top is resting on the trigger frame. I will just stick with the original.

[luke]

Originally some trigger designs were not threaded far enough, I thought I have fixed them, perhaps I missed one. If the lower hole is not threaded all the way, it could be the problem. It's an easy fix.

[BTAutoMag]

put the other trigger back in and see if that fixes it

[OPBN]

put the other trigger back in and see if that fixes it

I reinstalled the original trigger and its business as usual.

[BTAutoMag]

i appologise for my selective blindness... my wife hates me for it as well