Results 1 to 6 of 6

Thread: Manual for a Boo-yah ELCD Grip needed

  1. #1

    Manual for a Boo-yah ELCD Grip needed

    Hey guys,

    I picked up a Boo-yah elcd MAG grip, along with some other parts.
    As far as I am waware, there should be a specific on/off for this combination, made by Boo-yah.

    Can anyone help me with a manual/instructions for the grip?

    Would like to see if it fits to my current setup without any issues.

    Thanks,
    Nickless

  2. #2
    Join Date
    Nov 2000
    Location
    Milwaukee WI
    Posts
    1,392
    There was a specific on/off assembly Booyah made. They are very hard to find. But luckily a AGD ULT on/off will work perfectly. So, I would suggest just using one of those. But make sure your valve can take a ULT. classics and some RT Pro/Retro valves are not able to handle ULT's. All xvalves can though. Enjoy your BooYaah, they rip and are lots of fun. I have two of them and they are fantastic!

    Not sure on how to find a manual, but by just going through the buttons you should figure out all the settings pretty easy.

  3. #3
    Thanks for your reply.
    I should be fine with the settings and good to know that the ULT will work.

    I was more wondering about the installation... (which sear, how to install an adjust etc.)

  4. #4
    Join Date
    Nov 2000
    Location
    Milwaukee WI
    Posts
    1,392
    You need the AGD sear to be without the trigger rod. Just remove the rod from the sear, put in a ULT, and your good to go! Enjoy!!!

  5. #5
    Thanks a lot for your help - I will give it a try

  6. #6
    Join Date
    Sep 2002
    Location
    Live Free or Die
    Posts
    2,330
    This a scan of my Spyder manual. Although some is different I would think the programming parts are the same.
    http://www.bigevilonline.com/showthread.php?t=6457

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •