-
Manual for a Boo-yah ELCD Grip needed
Hey guys,
I picked up a Boo-yah elcd MAG grip, along with some other parts.
As far as I am waware, there should be a specific on/off for this combination, made by Boo-yah.
Can anyone help me with a manual/instructions for the grip?
Would like to see if it fits to my current setup without any issues.
Thanks,
Nickless
-
There was a specific on/off assembly Booyah made. They are very hard to find. But luckily a AGD ULT on/off will work perfectly. So, I would suggest just using one of those. But make sure your valve can take a ULT. classics and some RT Pro/Retro valves are not able to handle ULT's. All xvalves can though. Enjoy your BooYaah, they rip and are lots of fun. I have two of them and they are fantastic!
Not sure on how to find a manual, but by just going through the buttons you should figure out all the settings pretty easy.
-
Thanks for your reply.
I should be fine with the settings and good to know that the ULT will work.
I was more wondering about the installation... (which sear, how to install an adjust etc.)
-
You need the AGD sear to be without the trigger rod. Just remove the rod from the sear, put in a ULT, and your good to go! Enjoy!!!
-
Thanks a lot for your help - I will give it a try
-
This a scan of my Spyder manual. Although some is different I would think the programming parts are the same.
http://www.bigevilonline.com/showthread.php?t=6457
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules