Does anyone know what size the z lock pin is on a classic rt? A friend just bought one that has the pin broke off and we are trying to remove old and replace
Does anyone know what size the z lock pin is on a classic rt? A friend just bought one that has the pin broke off and we are trying to remove old and replace
Its a 1/8" hole. The pin is knurled so it should be the same size.
For classic regs, I buy a new 1/8" roll pin and use a dremel cut off wheel to get the length right. It's captured in its normal service and not pulled out, so you can use some loctite to hold it in if the hole has been beat a bit. Smooth the edges off if you use the dremel; steel pins can keep a nasty burr that will wait for you to forget.
thanks for the help guys! its nothing a bridgeport , an endmill , and a dremel can't fix