Results 1 to 4 of 4

Thread: Loose C Clip

  1. #1
    Join Date
    Jul 2007
    Location
    New Hampshire
    Posts
    483

    Loose C Clip

    I noticed that the C clip/washer was loose on one of my aftermarket bodies. Is this something I should be concerned about? It seems like the bolt spring would just hold it in place when the valve is installed.

  2. #2
    Join Date
    Sep 2008
    Location
    Sunny Florida- Woot!
    Posts
    5,240
    How loose? If it can fall out, just pull it out, open it up a bit and lock it back into place.

  3. #3
    Join Date
    Jul 2007
    Location
    New Hampshire
    Posts
    483
    Ha, I am dumb, I didn't even think of taking it out, I was just going to leave it as is. I will take a look at it. thanks

  4. #4
    Join Date
    Sep 2008
    Location
    Sunny Florida- Woot!
    Posts
    5,240
    Yeah, I wouldnt just leave it in place if it just flopping around in there. The spring should hold it in place, but if you'e not paying attention you could shove the valve in and bind it up or something. Better to just pull it out and open it up. Should take a minute or two to do.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •